logo3

English Chinese (Simplified) Danish Finnish French German Greek Hindi Norwegian Russian Spanish
Partner Site
  • http://prestigemotorbikecovers.co.uk/
  • http://prestigemotorbikecovers.co.uk/
  • http://prestigemotorbikecovers.co.uk/
  • http://prestigemotorbikecovers.co.uk/
  • http://prestigemotorbikecovers.co.uk/


COVER CARE

We recommend that you just sponge down the cover if it gets dirty with warm water. DO NOT put it in the washine machine, even on a cold water wash as this could damage the fabric.

INSTALLATION

Installing your new cover is simple Once you’ve identified the front of the cover, secure this area of the cover around the front tyre first, then pull the cover over the top of the handlebars and secure under the rear tire last.

Feel free to reinforce the inside of your cover with duct tape for any areas that will be in direct contact with sharp places. This ensures your cover will last as long as possible.

REMOVAL

The following procedure will make it easier to remove and install the cover whenever it is used:
Release both ends of the cover from under the tyres.
Fold up both sides onto the seat into a long roll.
Start at the front tyre and fold the cover in one foot folds from the front to the back.

If you use the same procedure each time, you will find it only takes about 30 seconds to install or to remove the cover.

The elastic at each end of the cover will keep it in place under all normal conditions. Use care in installing the cover on a motorcycle or scooter which has just been driven to be sure the material does not come in contact with HOT EXHAUST pipes.



.